Welcome to the FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
Need the latest SmartSDR or 4O3A Genius Product Software?
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
SmartSDR v4.1.3 | SmartSDR v4.1.3 Release Notes
SmartSDR v3.10.15 | SmartSDR v3.10.15 Release Notes
The latest 4O3A Genius Product Software and Firmware
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.
-
Re: How do I get my 6400M to show 2 different frequencies on the M Screen?
Pushing in the large ‘A’ or ‘B’ knobs at the bottom will bring up a menu allowing you to easily change a slice receiver’s band, mode, bandwidth, etc. push again to view the slice. Turn the knob to ch…1 -
Re: I just received my 6400M today. What should I do after I take it out of the box?
RCA plugs are among the easiest to solder. You could cut off the phono plug and solder on an RCA plug.2 -
Re: Which Mic input to use (6600M)?
For my Heil 781, I use Flex Radio’s 3-pin XLR to balanced line 1/4 inch cable. Cost $23.95.1 -
Re: Using the 6400M with SmartSDR
Under Multiflex, with both connected, your computer will control the slice receiver assigned to it and the radio’s front panel will control the slice assigned to it. Both will share the same antenna.1 -
Re: Flex-1500/3000 Is there a successor in sight?
Doesn’t the 6700 have roughly the form factor of the 3000?1
